fbpx
, , ,

SP11PMDD40

Availability:

30 in stock


SOLID STATE RELAY DC TO DC 40AMPS

574.00 (excluding 18% GST)

30 in stock

Compare

Description

A solid state relay (SSR) allows you to control high-current DC loads from lower voltage DC control circuitry. Solid state relays have several advantages over mechanical relays.
One such advantage is that they can be switched by a much lower voltage and at a much lower current than most mechanical relays. Also, because there are no moving contacts, solid state relays can be switched much faster and for much longer periods without wearing out.

Technical Data

SR. DESCRIPTION UNIT Power MOSFET
1 Continuous Drain Current at 20C° with Heatsink Amp 8A | 15A | 25A | 40A | 50A | 100A
2 Safe Continuous Rating Id at 55C° with Heatsink Amp 4A | 10A | 14A | 18A | 25A | 45A
3 Drain to Source Break Down Voltage Vdss (BR) VDC 100VDC | 200VDC | 55VDC
4 Minimum Holding Current mA 20
5 Max. OFF State Leakage Current mA 2
6 Turn ON Delay Time Td-ON mS 2.4
7 Turn OFF Delay Time Td-OFF mS 2.4
8 Isolation Voltage KV 2.5
9 Square Wave Output Hz 100

Product Details

MODEL SP11PMDD40
INPUT VOLTAGE 4-32VDC
INPUT CURRENT 4-16mA
OUTPUT VOLTAGE 5-55VDC
OUTPUT CURRENT AMP AT 20°C 40Amp
OUTPUT CURRENT HEATSINK AT 55°C 18Amp
OUTPUT TYPE OF HEATSINK B-77

Power Mosfet

Input LED Green Indication
Output N/O Confurgutions Only
Input-Output-Body Isolation 2.5kVA
Reverse polarity Protection on Input side
Turn ON/OFF Time Min. 2.4 Milli Second
Across the Load, Back EMF Diode Required for Inductive Load
Switching Speeds are Inherently Faster
No need to Derate Power Handing Capacity

Applications

Solenoid Valve Switching
PLC Interface
DC Clutch Break Switching
DC Motor Switching
Battery Power Switching
High Speed DC Switching
Magnetic Break Switching
Automobile Vehicle Switching
DC Motor Forward-Reverse Switching

Precaution

For Load Current More Than 3Amp External heatsink is Must
Apply Heatsink Pest on The Base Plate Of
The Before Mounting it External Heatsink
Fast Acting Fuse Require For Protection SSR
SSR Rating Should Be More or Equal to
Maximum Jerk Current Of Load
Do Not Check SSR Meter Or Continuity tester
Otherwise it Will Always Shows OPEN

Note

* Product Images are shown for illustrative purposes only and may differ from actual product

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “SP11PMDD40”

1 + 19 =

There are no reviews yet.

0
    0
    Your Cart
    Your cart is emptyReturn to Shop