30 In stock
₹665.00 (excluding 18% GST)
30 In stock
CompareA solid state relay (SSR) allows you to control high-current DC loads from lower voltage DC control circuitry. Solid state relays have several advantages over mechanical relays.
One such advantage is that they can be switched by a much lower voltage and at a much lower current than most mechanical relays. Also, because there are no moving contacts, solid state relays can be switched much faster and for much longer periods without wearing out.
| SR. | DESCRIPTION | UNIT | Power MOSFET |
| 1 | Continuous Drain Current at 20C° with Heatsink | Amp | 8A | 15A | 25A | 40A | 50A | 100A |
| 2 | Safe Continuous Rating Id at 55C° with Heatsink | Amp | 4A | 10A | 14A | 18A | 25A | 45A |
| 3 | Drain to Source Break Down Voltage Vdss (BR) | VDC | 100VDC | 200VDC | 55VDC |
| 4 | Minimum Holding Current | mA | 20 |
| 5 | Max. OFF State Leakage Current | mA | 2 |
| 6 | Turn ON Delay Time Td-ON | mS | 2.4 |
| 7 | Turn OFF Delay Time Td-OFF | mS | 2.4 |
| 8 | Isolation Voltage | KV | 2.5 |
| 9 | Square Wave Output | Hz | 100 |
| MODEL | KC50PMDD |
| INPUT VOLTAGE | 4-32VDC |
| INPUT CURRENT | 4-16mA |
| OUTPUT VOLTAGE | 5-55VDC |
| OUTPUT CURRENT AMP AT 20°C | 50Amp |
| OUTPUT CURRENT HEATSINK AT 55°C | 25Amp |
| OUTPUT TYPE OF HEATSINK | K-5 |
*Input LED Green Indication
*Output N/O Confurgutions Only
*Input-Output-Body Isolation 2.5kVA
*Reverse polarity Protection on Input side
*Turn ON/OFF Time Min. 2.4 Milli Second
*Across the Load, Back EMF Diode Required for Inductive Load
*Switching Speeds are Inherently Faster
*No need to Derate Power Handing Capacity
*Solenoid Valve Switching
*PLC Interface
*DC Clutch Break Switching
*DC Motor Switching
*Battery Power Switching
*High Speed DC Switching
*Magnetic Break Switching
Automobile Vehicle Switching
DC Motor Forward-Reverse Switching
*For Load Current More Than 3Amp External heatsink is Must
*Apply Heatsink Pest on The Base Plate Of The Before Mounting it External Heatsink
*Fast Acting Fuse Require For Protection SSR
*SSR Rating Should Be More or Equal to Maximum Jerk Current Of Load
*Do Not Check SSR Meter Or Continuity tester Otherwise it Will Always Shows OPEN
* Product Images are shown for illustrative purposes only and may differ from actual product
There are no reviews yet.