30 In stock
₹324.00 (excluding 18% GST)
30 In stock
CompareA solid state relay (SSR) allows you to control high-current DC loads from lower voltage DC control circuitry. Solid state relays have several advantages over mechanical relays.
One such advantage is that they can be switched by a much lower voltage and at a much lower current than most mechanical relays. Also, because there are no moving contacts, solid state relays can be switched much faster and for much longer periods without wearing out.
| SR. | DESCRIPTION | UNIT | Power MOSFET |
|---|---|---|---|
| 1 | Continuous Drain Current at 20C° with Heatsink | Amp | 8A | 15A | 25A | 40A | 50A | 100A |
| 2 | Safe Continuous Rating Id at 55C° with Heatsink | Amp | 4A | 10A | 14A | 18A | 25A | 45A |
| 3 | Drain to Source Break Down Voltage Vdss (BR) | VDC | 100VDC | 200VDC | 55VDC |
| 4 | Minimum Holding Current | mA | 20 |
| 5 | Max. OFF State Leakage Current | mA | 2 |
| 6 | Turn ON Delay Time Td-ON | mS | 2.4 |
| 7 | Turn OFF Delay Time Td-OFF | mS | 2.4 |
| 8 | Isolation Voltage | KV | 2.5 |
| 9 | Square Wave Output | Hz | 100 |
| MODEL | 07 PMDD 100 08 00 |
| INPUT CURRENT/VOLTAGE | 4-32VDC/4-16mA |
| OUTPUT VOLTAGE | 100VDC |
| OUTPUT CURRENT AMP AT 20°C | 8Amp |
| OUTPUT CURRENT HEATSINK AT 55°C | 4Amp |
| OUTPUT TYPEÂ OFÂ HEATSINK | J-15 |
1. Input LED Green Indication
2. Output N/O Confurgutions Only
3. Input-Output-Body Isolation 2.5kVA
4. Reverse polarity Protection on Input side
5. Turn ON/OFF Time Min. 2.4 Milli Second
6. Across the Load, Back EMF Diode Required for Inductive Load
7. Switching Speeds are Inherently Faster
8. No need to Derate Power Handing Capacity
1. Solenoid Valve Switching
2.PLC Interface
3.DC Clutch Break Switching
4.DC Motor Switching
5.Battery Power Switching
6.High Speed DC Switching
7.Magnetic Break Switching
8.Automobile Vehicle Switching
9.DC Motor Forward-Reverse Switching
1. For Load Current More Than 3Amp External heatsink is Must
2. Apply Heatsink Pest on The Base Plate Of The Before Mounting it External Heatsink
3. Fast Acting Fuse Require For Protection SSR
4. SSR Rating Should Be More or Equal to Maximum Jerk Current Of Load
5. Do Not Check SSR Meter Or Continuity tester Otherwise it Will Always Shows OPEN
* Product Images are shown for illustrative purposes only and may differ from actual product
There are no reviews yet.